How to install the handle？

November 25,2022

A handle must be installed on the surface of the cabinet to facilitate daily use, and there are many steps in the installation of the handle, let's take a look

1. Preparation

There are a lot of tools and materials needed to install handles on your cabinets, so be prepared in advance. First of all, clean the dust on the surface of the cabinet, wipe it with a damp towel, the surface is clean, it will not affect the installation of the handle.

2. Measure the hole distance of the handle

Then, it is necessary to measure the hole distance of the handle for installing the drawer, and the measurement must be accurate, otherwise it will affect the installation of the handle and make the installation of the handle not smooth. If the distance between the two holes is not horizontal, the handle will be inclined after installation, which will affect the appearance.

3. Determine the installation location

After the hole distance is measured, it is necessary to determine the installation position. This position is very important and should be determined according to the height of the user. If the handle is installed too high or too low, it will affect the use. First determine the approximate position, and whether it is easy to pull it by hand, in addition to looking at your height, you should also look at the height of the cabinet door. The higher the cabinet door, the higher the installation position. However, many cabinet doors also have a position for installing a handle, and you can directly install the handle on it. Generally speaking, the handle is installed between 1-2 inches below the cabinet door, and the position can be adjusted properly.

4. Drilling

After selecting the location, prepare the drilling tools and drill holes in the determined location. When drilling, pay attention to controlling the strength to prevent the cabinet door from cracking due to too much impulse when drilling. Also, protect your eyes to prevent injury to your eyes.

5. Install the handle

Finally, you can install the handle, first align the handle with the hole spacing, then tighten the screw with a screwdriver, and fix the handle on the cabinet door. After the handle is installed, check whether the cabinet door is easy to open by hand, and see if the pull-down handle is tightened. If there is no problem, the installation can be completed.

Post Tags: